PLANET WGSW-48040HP - Manual (Page 106)

Command Guide of WGSW-48040HP
4.2.45.71 poe pdcheck enable
Command:
poe pdcheck enable
poe Power Over Ethernet.
pdcheck Allows user to enable or disable per port PD Alive Check function.
enable PD alive check enable.
Default:
Disabled
Usage Guide:
To enable PD Ping Alive Check function of PoE for specific interface.
Example:
To enable PD Ping Alive Check function of PoE for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # poe pdcheck enable
4.2.45.72 poe pdcheck interval
Command:
poe pdcheck interval <10-300>
poe Power Over Ethernet.
pdcheck Allows user to enable or disable per port PD Alive Check function.
interval set how long system should be issue a ping request to PD for detecting whether PD is
alive or dead.
<10-300> interval <10~300>
Default:
30
Usage Guide:
To configure PD Ping Alive Check interval of PoE for specific interface.
Example:
To configure PD Ping Alive Check interval (100 seconds) of PoE for GigabitEthernet X/X.
-106-