PLANET WGSW-48040HP - Manual (Page 246)

Command Guide of WGSW-48040HP
Default:
0
Usage Guide:
To configure the Deadtime of Radius-Server
Example:
To configure the Deadtime (15) of Radius-Server
Switch# configure terminal
Switch (config)# radius-server deadtime 15
4.2.150 radius-server host
Command:
radius-server host [ auth-port ] [ acct-port ]
[ timeout ] [ retransmit ] [ key ]
radius-server Configure RADIUS
host Specify a RADIUS server
Hostname or IP address
acct-port UDP port for RADIUS accounting server
UDP port number
auth-port UDP port for RADIUS authentication server
UDP port number
key Server specific key (overrides default)
The shared key
retransmit Specify the number of retries to active server (overrides default)
Number of retries for a transaction
timeout Time to wait for this RADIUS server to reply (overrides default)
Wait time in seconds
Default:
None
Usage Guide:
To configure the Host of Radius-Server
Example:
To configure the Host (below table) of Radius-Server
-246-