PLANET WGSW-48040HP - Manual (Page 226)

Command Guide of WGSW-48040HP
4.2.129 poe temperature-protection enable
Command:
poe temperature-protection enable
poe Power Over Ethernet
temperature-protection Configure PoE over temperature protection to enable or disable.
enable poe temperature-protection enable
Default:
Enabled
Usage Guide:
To enable PoE Temperature Protection.
Example:
To enable PoE Temperature Protection.
Switch# configure terminal
Switch (config)# poe temperature-protection enable
4.2.130 poe temperature-threshold
Command:
poe temperature-threshold <0-100>
poe Power Over Ethernet
temperature-threshold Set a lower high temperature threshold for the secondary temperature alarm in degrees C.
<0-100> Specifies the new threshold temperature.
Default:
80
Usage Guide:
To enable PoE Temperature Protection.
Example:
To enable PoE Temperature Protection (70 degrees C).
Switch# configure terminal
Switch (config)# poe temperature-threshold 70
-226-