PLANET WGSW-48040HP - Manual (Page 51)

Command Guide of WGSW-48040HP
To enable the access management profile to allow SNMP / Telnet / HTTP services.
Example:
To create a Profile 1 enabling all services for VLAN 1 (IPv6 address 2001::7788) .
Switch# configure terminal
Switch (config)# access management 1 1 2001::7788 all
4.2.14 access-list ace
Command:
access-list ace action {deny, permit} | dmac-type {any, broadcast,
multicast, unicast} | frametype {any, arp, etype, ipv4, ipv4-icmp, ipv4-tcp, ipv4-udp,
ipv6, ipv6-icmp, ipv6-tcp, ipv6-udp} | ingress {any, interface 10GigabitEthernet |
GigabitEthernet } | logging {disable, next, policy, rate-limiter, shutdown,
tag-priority, vid} | next {, last}| policy | rate-limiter
{, disable} | redirect {disable, interface 10GigabitEthernet |
GigabitEthernet } | tag-priority {0-1, 0-3, 2-3, 4-5, 4-7, 6-7,
0-7>, any} | vid {, any}
ACE ID
action Access list action
dmac-type The type of destination MAC address
frametype Frame type
ingress Ingress
logging Logging frame information. Note: The logging feature only
works when the packet length is less than 1518 (without
VLAN tags) and the System Log memory size and logging rate
are limited.
next Insert the current ACE before the next ACE ID
policy Policy
rate-limiter Rate limiter
redirect Redirect frame to specific port
shutdown Shutdown incoming port. The shutdown feature only works
when the packet length is less than 1518 (without VLAN
tags).
tag-priority Tag priority
vid VID field
Default:
-51-