PLANET WGSW-48040HP - Manual (Page 212)

Command Guide of WGSW-48040HP
4.2.103 monitor destination
Command:
monitor destination interface 10GigabitEthernet | GigabitEthernet
monitor Set monitor configuration
destination The destination port. That is the port that trafficed should be mirrored to
Default:
Disabled
Usage Guide:
To configure Mirroring Port
Example:
To set Mirroring Port (GigabitEthernet 1/2)
Switch# configure terminal
Switch (config)# monitor destination interface GigabitEthernet 1/2
4.2.104 monitor source
Command:
monitor source interface * | 10GigabitEthernet | GigabitEthernet
{ both | rx | tx }
monitor Set monitor configuration
source The source port(s). That is the ports to be mirrored to the destination port.
Default:
Disabled
Usage Guide:
To configure Mirrored Port
Example:
To set Mirrored Port (GigabitEthernet 1/1, Tx + Rx)
Switch# configure terminal
Switch (config)# monitor source interface GigabitEthernet 1/1 both
-212-