PLANET WGSW-48040HP - Manual (Page 54)

Command Guide of WGSW-48040HP
Command:
access-list rate-limiter pps
Rate value
Default:
0
Usage Guide:
To set pps rate for all rate-limiter ID.
Example:
To set pps rate(10000 pps) for all rate-limiter ID.
Switch# configure terminal
Switch (config)# access-list rate-limiter pps 100
4.2.18 aggregation mode
Command:
aggregation mode dmac | ip | port | smac
dmac Destination MAC affects the distribution
ip IP address affects the distribution
port IP port affects the distribution
smac Source MAC affects the distribution
Default:
SMAC : Enabled
DMAC : Disabled
IP : Enabled
Port : Enabled
Usage Guide:
To configure static aggregation mode type.
Example:
To configure static aggregation mode type with Destination MAC affects the distribution and Source MAC affects the
distribution only.
Switch# configure terminal
Switch (config)# access-list rate-limiter pps 100
-54-