PLANET FGSW-2840 User Manual
PLANET Routers
This manual is related to the following products:
Table of contents
Document Outline
- 1. INTRODUCTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 5. COMMAND LINE INTERFACE
- 6. COMMAND LINE MODE
- 6.1 User EXEC Mode Commands
- 6.2 Privileged Mode Commands
- 6.2.1 broadcast command
- 6.2.2 configure command
- 6.2.3 copy command
- 6.2.4 disable command
- 6.2.5 firmware command
- 6.2.6 logout command
- 6.2.7 loopback Command
- 6.2.8 ping command
- 6.2.9 reboot command
- 6.2.10 reset command
- 6.2.11 tracert command
- 6.2.12 Clear command
- 6.2.13 exit command
- 6.2.14 history command
- 6.2.15 show command
- 6.3 Global Config Mode Commands
- 6.3.1 access-list Command
- 6.3.2 Contact-info Command
- 6.3.3 enable Command
- 6.3.4 hostname Command
- 6.3.5 interface Command
- 6.3.6 ip Command
- 6.3.7 lacp Command
- 6.3.8 location Command
- 6.3.9 logging Command
- 6.3.10 loopback-detection Command
- 6.3.11 mac Command
- 6.3.12 monitor Command
- 6.3.13 port-channel Command
- 6.3.14 qos Command
- 6.3.15 rmon Command
- 6.3.16 snmp-server Command
- 6.3.17 spanning tree Command
- 6.3.18 system-time Command
- 6.3.19 user Command
- 6.3.20 vlan Command
- 6.3.21 voice Command
- 6.3.22 clear Command
- 6.3.23 end Command
- 6.3.24 exit Command
- 6.3.25 history Command
- 6.3.26 show Command
- 7. SWITCH OPERATION
- 8. TROUBLESHOOTING
- APPENDIX A
- EC Declaration of Conformity