PLANET FGSW-2840 - Manual (Page 18)

User’s Manual of FGSW-2840 / FGSW-4840S
■ Reset Button
At front panel of Managed Switch, the reset button is designed for reboot the Managed Switch without turn off and on the
power. The following is the summary table of Reset button function :
Reset Button Pressed and Released Function
> 5 seconds : Factory Default
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as below:
。 Default Username: admin
。 Default Password: admin
。 Default IP address: 192.168.0.100
。 Subnet mask: 255.255.255.0
。 Default Gateway: 192.168.0.254
2.1.2 LED Indications
The front panel LEDs indicates instant status of port links, data activity, system power and system CPU status; helps monitor
and troubleshoot when needed. Figure 2-1-3 & Figure 2-1-4 shows the LED indications of the Managed Switch.
LED Indication
Figure 2-1-3: FGSW-2840 LED Panel
■ FGSW-2840 LED Definition
 System
LED Color Function
PWR Green Lights to indicate that the Switch has power.
SYS Green Lights and blinking to indicate the CPU is working.
 10/100Base-TX Interfaces (Port 1 to port 24)
LED
Color Function
Lights: To indicate the link through that port is successfully established at 100Mbps.
100
LNK/ACT
Green
Blink: To indicate that the Switch is actively sending or receiving data over that port.
10
LNK/ACT Orange
Lights:
Blink:
To indicate the link through that port is successfully established at 10Mbps.
To indicate that the Switch is actively sending or receiving data over that port.
18