PLANET FGSW-2840 - Manual (Page 238)

User’s Manual of FGSW-2840 / FGSW-4840S
238
Interface
Configuration
Mode
Use the interface type
number
command to enter
this mode from Global
Configuration mode.
FGSW-4840S
(config-if)#
Use the end command or press Ctrl+Z
to return to Privileged EXEC mode.
Enter exit command to return to Global
Configuration mode.
A port number must be specified in the
interface
command.
VLAN
Configuration
Mode
Use the vlan database
command to enter this mode
from Global Configuration
mode.
FGSW-4840S
(config-vlan)#
Use the end command or press Ctrl+Z
to return to Privileged EXEC mode.
Enter the exit command to return to
Global configuration mode.
Table 6-1: CLI Command Modes
The user is automatically in User EXEC Mode after the connection between the PC and the Managed
Switch is established by a telnet connection.
Each command mode has its own set of specific commands. To configure some commands, you
should access the corresponding command mode firstly.
 Global Configuration Mode :
In this mode, global commands are provided, such as the Spanning Tree, Schedule
Mode and so on.
 Interface Configuration Mode :
In this mode, users can configure one or several ports, different ports corresponds to
different commands.
a). Interface Ethernet: Configure parameters for an Ethernet port, such as Duplex-mode,
flow control status.
b). Interface range Ethernet: Configure parameters for several Ethernet ports.
c). Interface link-aggregation: Configure parameters for a link-aggregation, such as
broadcast storm.
d). Interface range link-aggregation: Configure parameters for multi-trunks.
e). Interface vlan: Configure parameters for the vlan-port.
 Vlan Configuration Mode :
In this mode, users can create a VLAN and add a specified port to the VLAN.
Some commands are global, that means they can be performed in all modes:
show : display all information of Managed Switch, for example: statistic information, port
information, VLAN information.
history : Display the commands history .