KEPCO MBT Series - Manual (Page 76)

3-38
MBTSVC111609
the program is running, the display indicates the output voltage and current for each step (n)
while it is being executed:
The program will execute all steps once, and stop with the display reading:
3.2.1.11.4 MODIFYING A PROGRAM
1. To modify a program, you must first enter program mode and select the program (PAR.
3.2.1.11.1).
2. Press NEXT or PREVIOUS (SHIFT then NEXT) to display the step(s) that require modifica-
tion.
3. Press or to display the Screen(s) that require modification.
4. Change the parameters by pressing the appropriate key(s) and changing the value (e.g., to
change the time duration for a step, display Screen 1 and press DELAY, enter the new
value, and press ENTER; this value has now been modified). After all parameters selected
for modification have been changed, press SHIFT then RESET to execute the program.
Once a parameter has been modified, the new value is stored, even if the unit is turned off.
5. To delete a step (with the exception of step 0), go to the step using NEXT (or SHIFT then
NEXT); press SHIFT then (DEL STEP function). The step is deleted and the display
shows the previous step.
6. To delete step 0, all the other steps must be deleted first. Use NEXT until display shows
the last step of the program.
VOLTAGE
MODE
CURRENT
MODE
POLARITY
REVERSED
REMOTE OUTPUT
ENABLED
STATUS
Running Stp: n
###V ###A
NOTE: ###V and ###A represent
either actual power supply out-
put voltage and current (output
enabled), or programmed out-
put and limit values (output dis-
abled).
VOLTAGE
MODE
CURRENT
MODE
POLARITY
REVERSED
REMOTE OUTPUT
ENABLED
STATUS
Stp: n
End of program
NOTE: For the sample program (PAR.
3.2.1.11.2), n = 2.
Stp n
End of program
NOTE: n = the last step of the
program selected