KEPCO MBT Series - Manual (Page 60)

3-22
MBTSVC111609
3.2.1.7.3 PROCEDURE USING IADJ AND NUMERIC KEYPAD
1. Press Iadj.
2. Enter current value via key pad, e.g., 2.1.
3. Press ENTER to confirm or CLEAR ENTRY to correct. Display will return to “Output is
OFF” or “Keypad control” display with either the new current value (ENTER) if the unit is
in current mode, or the old current value (CLEAR ENTRY). If the entered value is too high,
the display will indicate “Value too high,” then return to either “Output is OFF” or
“Keypad control” display, showing the previous value.
3.2.1.7.4 SLEW ( AND ) KEYS — M, MG MODELS
As described in PAR. 3.2.1.7.1 (M, MG Models) for the Iadj and numeric keys, the effect of the
slew keys is dependent upon model, commanded mode, output enabled/disabled, actual mode,
and the load.
Table 3-11 (M, MG Models) summarizes the effect of the slew keys for different conditions. The
first three columns reflect the status of the unit before the slew key is pressed. The fourth col-
umn shows how the adjustment will affect the status of the power supply. Refer to PAR.s 3.1.1
and 3.1.2 for more details regarding commanded and actual mode of operation (either voltage or
current).
VOLTAGE
MODE
CURRENT
MODE
POLARITY
REVERSED
REMOTE OUTPUT
ENABLED
STATUS
Curr limit =
###V ###A
VOLTAGE
MODE
CURRENT
MODE
POLARITY
REVERSED
REMOTE OUTPUT
ENABLED
STATUS
Output Curr =
###V ###A
or
NOTES: indicates LED may be either on or off.
###V and ###A will either be actual or programmed values of output voltage/voltage
limit and output current/current limit (see Tables 3-9 and 3-10).
indicates that blinking “:” appears only for OUTPUT ENABLED status.
VOLTAGE
MODE
CURRENT
MODE
POLARITY
REVERSED
REMOTE OUTPUT
ENABLED
STATUS
Curr limit = 2.1
###V ###A
VOLTAGE
MODE
CURRENT
MODE
POLARITY
REVERSED
REMOTE OUTPUT
ENABLED
STATUS
Output curr = 2.1
###V ###A
or