Remote control ***v ***a sh, Remote control 0 v 0 a sh, Remote control – KEPCO MBT Series User Manual
Page 45: V ***a sh, V ###a sh
MBTSVC111609
3-7
NOTES: A blinking “:” is represented by “ ” to indicate that the values displayed on the bottom line
of the alphanumeric display are “live,” i.e., actual values at the power supply output.
A blinking “sh” is represented by
sh
to indicate that the SHIFT key has been pressed,
and the next key that is pressed will be interpreted with the alternate meaning.
indicates STATUS LED may be on or off, depending on the actual status of the
power supply.
*** indicates the values displayed are actual values for output voltage and current.
### indicates that the values displayed for voltage and current are the actual internal
values prior to passing through the output relays. For commanded voltage mode the
display will show the programmed value for output voltage and 0 A for current. For
commanded current mode the display will show 0 V for voltage and the programmed
value for output current.
VOLTAGE
MODE
CURRENT
MODE
POLARITY
REVERSED
REMOTE
OUTPUT
ENABLED
STATUS
Remote control
***V ***A sh
A
M, MG models with
Output Enabled
VOLTAGE
MODE
CURRENT
MODE
POLARITY
REVERSED
REMOTE
OUTPUT
ENABLED
STATUS
Remote control
0 V 0 A sh
B
M, MG models with
Output disabled
VOLTAGE
MODE
CURRENT
MODE
POLARITY
REVERSED
REMOTE
OUTPUT
ENABLED
STATUS
Remote control
C
MR, MGR models with
Output enabled
***V ***A sh
VOLTAGE
MODE
CURRENT
MODE
POLARITY
REVERSED
REMOTE
OUTPUT
ENABLED
STATUS
Remote control
D
MR, MGR models with
Output disabled
###V ###A sh