10 changing the gpib address, Changing the gpib address -31, Polar nonrevrsed – KEPCO MBT Series User Manual
Page 69: V ###a, Gpib address = 6, Gpib address = 9 ###v ###a
MBTSVC111609
3-31
b. If changing from reversed to non-reversed, the display briefly shows
c. Display returns to “Output is OFF” or “Keypad control” display.
3.
To go back to previous polarity, press SHIFT then DC OFF.
3.2.1.10 CHANGING THE GPIB ADDRESS
The display should be reading either “Output is off” (PAR. 3.2.1.5.1, step 1) if the output is
disabled, or “Keypad control” (PAR. 3.2.1.5.1, step 2) if the output is enabled.
1.
Press SHIFT key. (Blinking “sh” appears on display.)
2.
Press DELAY (GPIB ADDRESS key).
3.
If the GPIB Address is correct, press ENTER or CLEAR ENTRY to accept the GPIB
address displayed. Display returns to either “Output is off” (PAR. 3.2.1.5.1, step 1) if
the output is disabled, or “Keypad control” (PAR. 3.2.1.5.1, step 2) if the output is
enabled.
4.
Enter new GPIB address — valid addresses are 0 to 30 (e.g., for address 9, enter 9).
VOLTAGE
MODE
CURRENT
MODE
POLARITY
REVERSED
REMOTE
OUTPUT
ENABLED
STATUS
Polar Nonrevrsed
NOTE: ###V and ###A represent
either actual power supply
output voltage and current
(output enabled) or pro-
grammed output and limit val-
ues (output disabled).
###V ###A
NOTE: indicates that blinking “:” appears only for OUTPUT
ENABLED status.
VOLTAGE
MODE
CURRENT
MODE
POLARITY
REVERSED
REMOTE
OUTPUT
ENABLED
STATUS
GPIB address = 6
NOTE: ###V and ###A represent
either actual power supply
output voltage and current
(output enabled) or pro-
grammed output and limit val-
ues (output disabled).
###V ###A
NOTE: The factory default address is 6.
VOLTAGE
MODE
CURRENT
MODE
POLARITY
REVERSED
REMOTE
OUTPUT
ENABLED
STATUS
GPIB address = 9
###V ###A