Solare Datensysteme Solar-Log - Manual (Page 229)

229
SMA
SMA Speedwire
Assigning IP addresses
•
A static IP address has to be assigned to the inverter. This is set to automatic by default. Please
refer to the inverter's user manual for more information.
•
Please select an IP address with the same subnet as the Solar-Log™.
For example: The Solar-Log™ has the IP address 192.168.178.49.
The inverter in this case has to have a free IP address in the same range (from 192.168.178.2 to
192.168.178.254).
•
Procedure: Start according to the inverter's instructions
Detection from the Solar-Log ™
•
For the detection on the Solar-Log ™ , select "SMA" as the inverter manufacturer in the Configurati-
on | Devices | Definition menu from the Network section. Confirm the selection with Save .
Detection from the Solar-Log 1200
•
When using the Solar-Log 1200, the detection can also be started from the display. Select "SMA" as
the manufacturer for the Speedwire detection from the "network" interface and start the detection.
Note for feed-in management
The feed-in management functions are also available for the Bluetooth interface. Please
note that the necessary settings have to be configured with the manufacturer's software.
Please refer to the inverter's user manual for more information.
Note
Please refer to the instructions in the manufacturer's installation manual in regard to ad-
dress types.
Note
Wiring with the bus.
Only one network connection is available per inverter with the integrated Speedwire inter-
face.
A router or switch is required when using several inverters or when using the Ethernet
(RS45) interface on the Solar-Log™.