TA Triumph-Adler DC 2060 - Manual (Page 116)

System Settings
3-16
3 Press [+] and [-] to specify the widths to
erase the borders.
The range for the width is as follows.
4 Press [Close]. The touch panel will return to the Copy Default screen.
Selecting Maximum Number of Copies
You can limit the maximum number of copies from 1 to 9999.
1 Access the Copy Default screen. (For instructions, refer to Accessing the Copy Default Screen on
page 3-3.)
2 Press [S] or [T] to select Preset limit
and press [Change #].
3 Use the numeric keys to enter the
maximum number of copies from 1 to
9999.
4 Press [Close]. The touch panel will return to the Copy Default screen.
Enabling Repeat Copy
Repeat copy allows to print the original document which was copied and stored in the copier. You
can enable or disable repeat copy and set it as the default.
NOTE: This menu not available when the copier is equipped with the optional security kit.
1 Access the Copy Default screen. (For instructions, refer to Accessing the Copy Default Screen on
page 3-3.)
Default erase width Back
System Menu
Adjust default setting of erase width.
Copy Default
Center Border
2) (0
" " ¼ ½
-
2) (0
Setting Range
Inch models 0 to 2" (in 1/8" increments)
Metric models 0 to 50 mm (in 1-mm increments)
System Menu
Copy Default
Default menu
Auto Rotation
Default margin width
Default erase width
Change #
System Menu / Counter
Setting mode
Preset limit
Left
Border
Center
Set
Rotate
¼ " ½ "
¼ " 0 "
Sort/Offset Sort:On/Offset:Off
Preset limit Back
System Menu
Set output quantity.
Copy Default
Set
-