Yaskawa Sigma-5 User Manual: Design and Maintenance - Rotary Motors - Analog Voltage and Pulse Train Reference - Manual (Page 324)

8 Monitor Displays (Un )
8.5.2 Interpreting Output Signal Display Status
8-8
8.5.2 Interpreting Output Signal Display Status
The status of allocated signals is displayed on the 7-segment display on the panel operator.
Output terminals correspond to LED numbers as shown in the following table.
• When the output signal is in OFF status, the top segment (LED) is lit.
• When the output signal is in ON status, the bottom segment (LED) is lit.
Note: Input signals use the following circuit configuration.
• OFF: Transistor OFF
• ON: Transistor ON
Example
8.5.3 Output Signal Display Example
Output signals are displayed as shown below.
• When the ALM signal is OFF
Display LED
Number
Output Terminal Name
Signal Name
(Factory Setting)
1 CN1-31, -32 ALM
2 CN1-25, -26 /COIN or /V-CMP
3 CN1-27, - 28 /TGON
4 CN1-29, -30 /S-RDY
5 CN1-37 ALO1
6 CN1-38 ALO2
7 CN1-39 ALO3
8 − Reserved
4 3 2 1
Top: OFF
Bottom: ON
Number 6 7 8 5
Analog
ON: Transistor ON
The top segment of
number 1 is lit.
7 6 8 5 4 3 2 1
Analog