Yaskawa Sigma-5 User Manual: Design and Maintenance - Rotary Motors - Analog Voltage and Pulse Train Reference - Manual (Page 318)

8 Monitor Displays (Un )
8-2
8.1 List of Monitor Displays
The monitor displays can be used for monitoring the I/O signal status, and SERVOPACK internal status.
Refer to the following table.
∗1. For details, refer to 8.4 Monitoring Input Signals.
∗2. For details, refer to 8.5 Monitoring Output Signals.
∗3. For details, refer to 8.3 Reading 32-bit Data in Decimal Displays.
∗4. For details, refer to 5.4.4 Electronic Gear.
∗5. For details, refer to 9.3.3 Setting Encoder Output Pulses (PAO, PBO, and PCO).
∗6. If the reference pulse input multiplication switching function is enabled, the reference pulse will be multiplied by n to
obtain the reference. This function is supported by software version 001A or later.
∗7. The monitor Un022 can be used only with SGDV- B SERVOPACKs. For details, refer to 2 Installation
of Σ -V Series USER’S MANUAL, Setup, Rotational Motor (No.: SIEP S800000 43).
Parameter
No.
Description Unit
Un000 Motor rotating speed min -1
Un001 Speed reference min -1
Un002 Internal torque reference (in percentage to the rated torque) %
Un003 *3
Rotational angle 1 (encoder pulses from the phase-C origin:
decimal display)
encoder pulse
∗4
Un004 Rotational angle 2 (from polarity origin (electric angle)) deg
Un005 *1 Input signal monitor −
Un006 *2 Output signal monitor −
Un007 *6 Input reference pulse speed (valid only in position control) min -1
Un008
*6 Position error amount (valid only in position control) reference unit
Un009
Accumulated load ratio (in percentage to the rated torque:
effective torque in cycle of 10 seconds)
%
Un00A
Regenerative load ratio (as a percentage of the processable
regenerative power: regenerative power consumption in cycle
of 10 seconds)
%
Un00B
Power consumed by DB resistance
(in percentage to the processable power at DB activation: dis-
played in cycle of 10 seconds) %
Un00C *3, *6 Input reference pulse counter reference unit
Un00D *3 Feedback pulse counter encoder pulse
∗4
Un00E
*3 Fully-closed feedback pulse counter external encoder resolution
∗5
Un012 Total operation time 100 ms
Un013
*3 Feedback pulse counter reference unit
Un014 Effective gain monitor (gain settings 1 = 1, gain settings 2 = 2) −
Un015 Safety I/O signal monitor −
Un020 Motor rated speed min -1
Un021 Motor maximum speed min
-1
Un022 *7
Installation environment monitor
(Operation conditions in various environments can be moni-
tored.)
%