Yaskawa Sigma-5 User Manual: Design and Maintenance - Rotary Motors - Analog Voltage and Pulse Train Reference - Manual (Page 114)

4 Trial Operation
4.6.4 Operator Displays during Testing without Motor
4-16
4.6.4 Operator Displays during Testing without Motor
The status display changes as shown below to show that the test without a motor is being executed.
(1) Display on Panel Operator
∗ The test without a motor operation in progress is indicated with tSt.
Note: The test without a motor status is not displayed during alarm occurs (A.†††).
(2) Display on Digital Operator
An asterisk ( ∗) is displayed before status display to indicate the test without a motor operation is in progress.
(Example: Status of power to the servomotor is OFF)
Note: The test without a motor status is not displayed during alarm occurs (A.†††).
Display Status
run ⇔ tSt Power is supplied to the servomotor.
bb ⇔ tSt Power to the servomotor is OFF.
Pot ⇒ not ⇒ tSt Forward or reverse run is prohibited.
Pot ⇔ tSt Forward run is prohibited.
not ⇔ tSt Reverse run is prohibited.
Hbb ⇔ tSt In hard-wire base block (safety) state.
Displayed alternately
Analog
Display Status
*RUN Power is supplied to the servomotor.
*BB Power to the servomotor is OFF.
*PT NT Forward or reverse run is prohibited.
*P-OT Forward run is prohibited.
*N-OT Reverse run is prohibited.
*HBB In hard-wire base block (safety) state.
∗ B B − P R M / M O N −
U n 0 0 0 = 0 0 0 0 0 0
U n 0 0 2 = 0 0 0 0 0 0
U n 0 0 8 = 0 0 0 0 0 0 0 0 0 0 0
U n 0 0 D = 0 0 0 0 0 0 0 0 0 0 0