HEIDENHAIN IK 5494-2D - Manual (Page 351)

329
1
0
Supervisor Setup
Motors off
Pressing the button toggles all Axis motors on or off. This function duplicates the Motors Off found in the
Tools menu.
Swap Z joystick
Pressing the button toggles the vertical joystick motion between the Y-axis and the Z-axis.
Swap Z digital positioner
Pressing the button toggles the vertical trackball motion between the Y-axis and the Z-axis.
Swap Q joystick
Pressing the button toggles the vertical joystick motion between the Y-axis and the rotary Q-axis.
Go to here
Pressing the button inserts a Goto Here step into the current line of
the program being recorded. This function duplicates the Goto Here
found on the program toolbar.
Pause prg
Pressing the button pauses the current program execution. This func-
tion duplicates the Pause found on the program toolbar.
Run prg
Pressing the button runs the current program starting from
the current step, and is typically used to resume program
execution after a pause. This function duplicates the Run
Program From Current Step found on the program toolbar.
Joystick and Footswitch Setup