HEIDENHAIN IK 5494-2D - Manual (Page 345)

323
1
0
Supervisor Setup
NOTE
The default 7 pixel diameter strikes an excellent balance of sensitivity and ease of
operation, and should be retained if possible.
Specifying automatic redraw of part view
During program execution, the part view is periodically redrawn to show the probe position changing as
features are measured. The part view is redrawn each time the probe moves the distance specified in the
data field. Change the redraw rate by entering a new value into the Minimum amount... field.
Zooming to view whole part on measurements
Check the Zooming to fit... box to zoom to display the entire part when a feature is measured or created.
Zooming to view whole part on constructions
Check the Zoom to fit... box to zoom to display the entire part when a feature is constructed.
Displaying feature numbers and names on part views
Feature properties and the part view options screen can be configured to show only features with numbers
or features with numbers and names of selected features.
When feature properties are configured to show names, the Part View options screen can be set to show
numbers or numbers and names on the part view screen.
Display Setup