HEIDENHAIN iTNC 530 (340 49x-03) Pilot User Manual
Itnc 530
This manual is related to the following products:
Table of contents
Document Outline
- Pilot
- Conversational format
- iTNC 530
- The Pilot
- Contents
- Fundamentals
- Programs/Files
- Initiating a new part program
- Choosing the Screen Layout
- Absolute Cartesian Coordinates
- Incremental Cartesian Coordinates
- Circle Center and Pole: CC
- Angle Reference Axis
- Polar coordinates
- Defining Tools
- Tool compensation
- Datum Setting without a 3-D Touch Probe
- Setup and Measurement with 3-D Touch Probes
- Contour Approach and Departure
- Path functions
- FK Free Contour Programming
- Subprograms and program section repeats
- Working with Cycles
- Cycles for Drilling, Tapping and Thread Milling
- Overview
- CENTERING (Cycle 240)
- DRILLING (Cycle 200)
- REAMING (Cycle 201)
- BORING (Cycle 202)
- UNIVERSAL DRILLING (Cycle 203)
- BACK BORING (Cycle 204)
- UNIVERSAL PECKING (Cycle 205)
- BORE MILLING (Cycle 208)
- TAPPING NEW with floating tap holder (Cycle 206)
- RIGID TAPPING without a floating tap holder NEW (Cycle 207)
- TAPPING WITH CHIP BREAKING (Cycle 209)
- THREAD MILLING (Cycle 262)
- THREAD MILLING/COUNTERSINKING (Cycle 263)
- THREAD DRILLING/MILLING (Cycle 264)
- HELICAL THREAD DRILLING/MILLING (Cycle 265)
- OUTSIDE THREAD MILLING (Cycle 267)
- Pockets, Studs and Slots
- Point Patterns
- SL Cycles
- Overview
- General Information
- CONTOUR GEOMETRY (Cycle 14)
- CONTOUR DATA (Cycle 20)
- PILOT DRILLING (Cycle 21)
- ROUGH-OUT (Cycle 22)
- FLOOR FINISHING (Cycle 23)
- SIDE FINISHING (Cycle 24)
- CONTOUR TRAIN (Cycle 25)
- CYLINDER SURFACE (Cycle 27, software option 1)
- CYLINDER SURFACE (Cycle 28, software option 1)
- CYLINDER SURFACE (Cycle 29, software option 1)
- CYLINDER SURFACE (Cycle 39, software option 1)
- Cycles for Multipass Milling
- Coordinate Transformation Cycles
- Special Cycles
- The PLANE Function (software option 1)
- Overview
- Space Angle Definition (PLANE SPATIAL)
- Projection Angle Definition (PLANE PROJECTED)
- Euler Angles Definition (PLANE EULER)
- Vector Definition (PLANE VECTOR)
- Points Definition (PLANE POINTS)
- Incremental Space Angle (PLANE RELATIVE)
- Axis angle definition (PLANE VECTOR)
- Resetting the Plane Definition (PLANE RESET)
- Automatic Positioning (MOVE/STAY/TURN)
- Select a Possible Solution (SEQ +/-)
- Selection of the type of transformation
- Inclined-Tool Machining in the Tilted Plane
- DXF data processing (software option)
- Graphics and Status Displays
- ISO Programming
- Miscellaneous Functions M