Vector definition (plane vector) – HEIDENHAIN iTNC 530 (340 49x-03) Pilot User Manual
Page 105
105
The PLANE Fun
c
tion
(softw
ar
e
o
pt
io
n
1
)
Vector Definition (PLANE VECTOR)
8
Press SPECIAL TNC FUNCTIONS.
8
Press TILT MACHINING PLANE, and then PLANE VECTOR
8
X component of base vector?:
X component BX of the base vector
B (see figure at top right)
8
Y component of base vector?:
Y component BY of the base vector
B (see figure at top right)
8
Z component of base vector?:
Z component BZ of the base vector
B (see figure at top right)
8
X component of normal vector?:
X component NX of the normal
vector N (see figure at lower right)
8
Y component of normal vector?:
Y component NY of the normal
vector N (see figure at lower right)
8
Z component of normal vector?:
Z component NZ of the normal
vector N
8
Continue with the positioning properties (see “Automatic Positioning
(MOVE/STAY/TURN)” on page 110).
5 PLANE VECTOR BX0.8 BY-0.4 BZ-
0.4472 NX0.2 NY0.2 NZ0.9592 MOVE SETUP10 F500
Before programming, note the following:
The TNC calculates standardized vectors from the values you
enter.