HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 122)

122
IS
O P
ro
g
ra
mmi
ng
Q-parameter functions
D00 Assign a numerical value
D01 Calculate and assign the sum of two values
D02 Calculates and assigns the difference of two
values.
D03 Calculates and assigns the product of two values.
D04 Calculate and assign the quotient of two values
D05 Calculate and assign the square root of a number
D06 Calculate the sine of an angle in degrees and
assign it to a parameter
D07 Calculate the cosine of an angle in degrees and
assign it to a parameter
D08 Calculate and assign the square root of the sum of
two squares (Pythagorean theorem)
D09 If equal, jump to the given label
D10 If not equal, jump to the given label
D11 If greater than, jump to the given label
D12 If less than, jump to the given label
D13 Calculate the angle from the arc tangent of two
sides or from the sine and cosine of the angle and
assign it to a parameter
D14 Output text to screen
D15 Output text or parameter contents through the
data interface
D19 Transmit numerical values or Q parameters to the
PLC