HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 71)

71
Pockets, Studs and Slots
CIRCULAR STUD FINISHING (Cycle 215)
8 CYCL DEF: Select Cycle 215 C. STUD FINISHING
8 set-up clearance: Q200
8 Depth: Distance between workpiece surface and bottom of stud:
Q201
8 Feed rate for plunging: Q206
8 Plunging depth: Q202
8 Feed rate for milling: Q207
8 Workpiece surface coordinate: Q203
8 2nd set-up clearance: Q204
8 Center in 1st axis: Q216
8 Center in 2nd axis: Q217
8 Workpiece blank diameter: Q222
8 Finished part diameter: Q223
The TNC automatically pre-positions the tool in the tool axis and working
plane. If the pecking depth is greater than or equal to the depth, the tool
drills to the depth in one plunge.
X
Z
Q200
Q201
Q206
Q203
Q204
Q202
X
Y
Q223
Q217
Q216
Q207
Q222