HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 51)

51
Cyc
les for Drilling, Tappi
n
g and
Thread Mi
lling
UNIVERSAL DRILLING (Cycle 203)
8 CYCL DEF: Select Cycle 203 UNIVERSAL DRILLING
8 Set-up clearance: Q200
8 Depth: Distance between workpiece surface and bottom of hole:
Q201
8 Feed rate for plunging: Q206
8 Plunging depth: Q202
8 Dwell time at top: Q210
8 Workpiece surface coordinate: Q203
8 2. Set-up clearance: Q204
8 Decrement after each pecking depth: Q212
8 No. of chip breaks before retraction: Q213
8 Min. pecking depth if a decrement has been entered: Q205
8 Dwell time at depth: Q211
8 Feed rate for retraction: Q208
8 Retraction rate for chip breaking: Q256
X
Z
Q200
Q201
Q206
Q202
Q210
Q203
Q204
Q211
Q208