HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 110)

110
The PLANE Fun
c
tion
(softw
ar
e
o
pt
io
n
1
)
Automatic Positioning (MOVE/STAY/TURN)
After you have entered all parameters for the plane definition, you must
specify how the rotary axes will be positioned to the calculated axis
values:
8 The PLANE function is to automatically position the rotary
axes to the calculated position values. The position of the
tool relative to the workpiece is to remain the same. The
TNC carries out a compensating motion in the linear axes.
8 The PLANE function is to automatically position the rotary
axes to the calculated position values, but only the rotary
axes are positioned. The TNC does not carry out a
compensating motion in the linear axes.
8 You will position the rotary axes later in a separate
positioning block.
If you select either the MOVE or the TURN option (PLANE function is to
position the axes automatically), then the following two parameters must
still be defined:
8 Dist. tool tip – center of rot. (incremental): The TNC tilts the tool
(or table) relative to the tool tip. The SETUP parameter shifts the center
of rotation of the positioning movement relative to the current position
of the tool tip.
8 Feed rate ? F= : Contour speed at which the tool should be positioned.