HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 125)

125
Miscellan
e
ous Fun
c
tion
s M
1)
TCPM: Tool Center Point Management
M130 Moving to position in an untilted coordinate
system with a tilted working plane
M134 Exact stop for positioning with rotary axes
M135 Reset M134
M136 Feed rate F in millimeters per spindle revolution
M137 Feed rate F in millimeters per minute
M138 Selection of tilted axes for M114, M128 and the
Tilt Working Plane cycle
M140 Retraction from the contour in the tool-axis
direction
M141 Suppress touch probe monitoring
M142 Delete modal program information
M143 Delete basic rotation
M144 Compensating the machine’s kinematic
configuration for ACTUAL/NOMINAL positions at
end of block (software option)
M145 Reset M144
M148 Automatically retract tool from the contour at an
NC stop
M149 Reset M148
M150 Suppress limit-switch error message
M200 Miscellaneous functions for laser cutting
machines
.
.
.
M204 See User’s Manual
M110 Constant contouring speed of tool cutting edge
on arcs (only feed-rate decrease)
M111 Reset M109/M110
M114 Automatic compensation of machine geometry
when working with tilted axes (software option)
M115 Reset M114
M116 Feed rate for rotary axes in mm/min (software
option)
M117 Reset M116
M118 Superimpose handwheel positioning during
program run
M120 Pre-calculate radius-compensated position (LOOK
AHEAD)
M124 Do not include points when executing non-
compensated line blocks
M126 Shortest-path traverse of rotary axes
M127 Reset M126
M128 Maintain the position of the tool tip when
positioning with tilted axes (TCPM)
1)
(software option)
M129 Reset M128