HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 86)

86
Cyc
les for Multipass
Milling
MULTIPASS MILLING (Cycle 230)
8 CYCL DEF: Select Cycle 230 MULTIPASS MILLING
8 Starting point in 1st axis: Q225
8 Starting point in 2nd axis: Q226
8 Starting point in 3rd axis: Q227
8 1. side length: Q218
8 2nd side length: Q219
8 Number of cuts: Q240
8 Feed rate for plunging: Q206
8 Feed rate for milling: Q207
8 Stepover feed rate: Q209
8 Set-up clearance: Q200
From the current position, the TNC positions the tool at the
starting point, first in the working plane and then in the tool
axis. Pre-position the tool in such a way that no collision
between tool and clamping devices can occur.
X
Z
Q200
Q227
Q206
X
Y
Q226
Q225
Q219
Q218
Q207
Q209
N = Q240