HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 106)

106
The PLANE Fun
c
tion
(softw
ar
e
o
pt
io
n
1
)
Points Definition (PLANE POINTS)
8 Press SPECIAL TNC FUNCTIONS.
8 Press TILT WORKING PLANE, and then PLANE POINTS
8 X coordinate of 1st plane point?: X coordinate P1X
8 Y coordinate of 1st plane point?: Y coordinate P1Y
8 Z coordinate of 1st plane point?: Z coordinate P1Z
8 X coordinate of 2nd plane point?: X coordinate P2X
8 Y coordinate of 2nd plane point?: Y coordinate P2Y
8 Z coordinate of 2nd plane point?: Z coordinate P2Z
8 X coordinate of 3rd plane point?: X coordinate P3X
8 Y coordinate of 3rd plane point?: Y coordinate P3Y
8 Z coordinate of 3rd plane point?: Z coordinate P3Z
8 Continue with the positioning properties (see “Automatic Positioning
(MOVE/STAY/TURN)” on page 110).
5 POINTS P1X+0 P1Y+0 P1Z+20 P2X+30 P2Y+31 P2Z+20
P3X+0 P3Y+41 P3Z+32.5 MOVE SETUP10 F500
Before programming, note the following:
The connection from Point 1 to Point 2 determines the
direction of the tilted principal axis (X for tool axis Z).
The three points define the slope of the plane. The position
of the active datum is not changed by the TNC.