HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 117)

117
G
ra
p
hics and Status
Displays
Status displays
In the program run modes a window in the lower part of the screen
shows information on
„ Tool position
„ Feed rate
„ Active miscellaneous functions
Further status information is available via soft key for display in an
additional window:
8 Activate the Overview tab: Display of the most important
information
8 Activate POS tab: Display of positions
8 Activate TOOL tab: Display of tool data
8 Activate TRANS tab: Display of active coordinate
transformations
8 Shift tabs to the left
8 Shift tabs to the right
Select the PROGRAM+STATUS or POSITION+STATUS
layout.