HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 50)

50
Cyc
les for Drilling, Tappi
n
g and
Thread Mi
lling
BORING (Cycle 202)
8 CYCL DEF: Select Cycle 202 BORING
8 Set-up clearance: Q200
8 Depth: Distance between workpiece surface and bottom of hole:
Q201
8 Feed rate for plunging: Q206
8 Dwell time at depth: Q211
8 Feed rate for retraction: Q208
8 Workpiece surface coordinate: Q203
8 2. Set-up clearance: Q204
8 Disengaging direction (0/1/2/3/4) at bottom of hole: Q214
8 Angle for oriented spindle stop: Q336
„
The TNC and the machine tool must be specially prepared
by the machine tool builder for the use of the BORING
Cycle.
„ This cycle requires a position-controlled spindle.
Danger of collision! Choose a disengaging direction that
moves the tool away from the wall of the hole.
X
Z
Q200
Q201
Q206
Q211
Q203
Q204
Q208