HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 45)

45
Working w
ith
C
y
cles
Graphic support for programming cycles
The TNC supports you during cycle definition with graphic
representations of the input parameters.
Calling cycles
The following cycles become effective automatically as soon as they are
defined in the machining program:
„ Coordinate Transformation Cycles
„ DWELL TIME cycle
„ The SL cycles CONTOUR and CONTOUR DATA
„ Point Patterns
„
Cycle TOLERANCE
All other cycles take effect after they are called with
„ CYCL CALL : effective blockwise
„
CYCL CALL PAT : effective blockwise in combination with point tables
„ CYCL CALL POS : effective blockwise after the position defined in the
CYCL CALL POS block was approached
„
M99 : effective blockwise
„
M89 : effective modally (depends on machine parameters)