HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 39)

39
F
K
Fre
e
Con
tou
r P
rog
ra
mming
Data relative to block N: Direction and distance of the contour
element
The coordinates and angles for relative data are always
programmed in incremental dimensions. You must also enter
the block number of the contour element on which the data
are based.
Known data Soft keys
Angle between a straight line and another element or
between the entry tangent of the arc and another
element
Straight line parallel to another contour element
Distance from a straight line to a parallel contour
element
17 FL LEN 20 AN+15
18 FL AN+105 LEN 12.5
19 FL PAR 17 DP 12.5
20 FSELECT 2
21 FL LEN 20 IAN+95
22 FL IAN+220 RAN 18
X
Y
105°
12.5
12.5
95°
220°
15°
20
20