HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 103)

103
The PLANE Fun
c
tion
(softw
ar
e
o
pt
io
n
1
)
Projection Angle Definition (PLANE PROJECTED)
8 Press SPECIAL TNC FUNCTIONS.
8 Press TILT MACHINING PLANE, and then PLANE PROJECTED
8 Proj. angle 1st coordinate plane?: Projected angle of the tilted
machining plane in the 1st coordinate plane of the fixed machine
coordinate system (see figure at top right)
8 Proj. angle 2nd coordinate plane?: Projected angle in the 2nd
coordinate plane of the fixed machine coordinate system (see figure
at top right)
8 ROT angle of the tilted plane?: Rotation of the tilted coordinate
system around the tilted tool axis (corresponds to a rotation with
Cycle 10 ROTATION, see figure at lower right)
8 Continue with the positioning properties (see “Automatic Positioning
(MOVE/STAY/TURN)” on page 110).
5 PLANE PROJECTED PROPR+24 PROMIN+24 PROROT+30 MOVE SETUP10
F500
Before programming, note the following:
You can only use projection angles if a rectangular cuboid is
to be machined. Otherwise distortions could occur on the
workpiece.