HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 98)

98
Special Cycles
DWELL TIME (Cycle 9)
This causes the execution of the next block within a running program to
be delayed by the programmed dwell time.
8 CYCL DEF: Select Cycle 9 DWELL TIME
8 Enter the dwell time in seconds
PGM CALL (Cycle 12)
8 CYCL DEF: Select Cycle 12 PGM CALL
8 Enter the name of the program to be called
48 CYCL DEF 9.0 DWELL TIME
49 CYCL DEF 9.1 DWELL 0.5
Cycle 12 PGM CALL must be called to become active.
7 CYCL DEF 12.0 PGM CALL
8 CYCL DEF 12.1 LOT31
9 L X+37.5 Y-12 R0 FMAX M99
0 BEGIN PGM
LOT31 MM 7 CYCL DEF 12.0
PGM CALL
8 CYCL DEF 12.1
LOT31
9 ... M99
END PGM LOT31