HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 73)

73
Poin
t Patt
erns
LINEAR PATTERN (Cycle 221)
8 CYCL DEF: Select Cycle 221 LINEAR PATTERN
8 Starting point in 1st axis: Q225
8 Starting point in 2nd axis: Q226
8 Spacing in 1st axis: Q237
8 Spacing in 2nd axis: Q238
8 Number of columns: Q242
8 Number of lines: Q243
8 Angle of rotation: Q224
8 Set-up clearance: Q200
8 Workpiece surface coordinate: Q203
8 2. Set-up clearance: Q204
8 Move to clearance height: Q301
The TNC automatically pre-positions the tool in the tool axis and working
plane.
„ Cycle 221 LINEAR PATTERN is effective immediately upon
definition.
„ Cycle 221 automatically calls the last defined fixed cycle.
„
You can combine the following cycles with Cycle 221: 1, 2,
3, 4, 5, 17, 200, 201, 202, 203, 204, 205, 206, 207, 208,
209, 212, 213, 214, 215, 240, 251, 252, 253, 262, 263, 264,
265, 267.
„ In combined cycles, the set-up clearance, surface
coordinate and 2nd set-up-clearance are always taken from
Cycle 221.
X
Z
Q200
Q203
Q204
X
Y
Q226
Q225
Q224
Q238
Q237
N = Q242
N = Q243