HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 115)

115
G
ra
p
hics and Status
Displays
Graphics and Status Displays
Defining the Workpiece in the Graphic Window
The dialog prompt for the BLK FORM appears automatically whenever
you create a new part program.
„
Create a new program or, if you are already in a program, press the soft
key BLK FORM
„ Spindle axis
„ MIN and MAX point
The following is a selection of frequently needed functions.
Interactive Programming Graphics
The TNC can generate a two-dimensional graphic of the contour while
you are programming it:
8 Automatic graphic generation during programming
8 Manually start graphic generation
8 Generate interactive graphics blockwise
See “Graphics and Status Displays.”
Select the PROGRAM+GRAPHICS layout.