HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 79)

79
SL Cycles
FLOOR FINISHING (Cycle 23)
During finishing, the surface is machined parallel to the contour and to the
depth previously entered under ALLOWANCE FOR FLOOR.
8 CYCL DEF: Select Cycle 23 FLOOR FINISHING
8 Feed rate for plunging: Q11
„ Feed rate for roughing: Q12
8 Feed rate for retraction: Q208
SIDE FINISHING (Cycle 24)
Finishing the individual contour elements
8 CYCL DEF: Select Cycle 24 SIDE FINISHING
8 Direction of rotation: Q9. Clockwise Q9 = –1; counterclockwise
Q9 = +1
8 Plunging depth: Q10
8 Feed rate for plunging: Q11
8 Feed rate for roughing: Q12
8 Finishing allowance for side: Q14; Allowance for finishing in several
passes
Call Cycle 22 ROUGH-OUT before calling Cycle 23.
X
Z
Q11
Q12
Call Cycle 22 ROUGH-OUT before calling Cycle 24.
X
Z
Q11
Q12
Q10