HEIDENHAIN iTNC 530 (340 49x-03) Pilot - Manual (Page 83)

83
SL Cycles
CYLINDER SURFACE (Cycle 29, software option 1)
Cycle 29 CYLINDER SURFACE enables you to program a ridge in only two
axes, and then machine it on a cylindrical surface without distorting the
angle of the slot walls.
8 Define a contour in a subprogram and list it in Cycle 14 CONTOUR
GEOMETRY
8 CYCL DEF: Select Cycle 29 CYL SURFACE RIDGE
8 Milling depth: Q1
8 Finishing allowance for side: Q3
8 Set-up clearance: Q6. Distance between tool and workpiece surface
8 Plunging depth: Q10
8 Feed rate for plunging: Q11
8 Feed rate for roughing: Q12
8 Cylinder radius: Q16. Radius of the cylinder
8 Dimension type: Q17. Degrees = 0; mm/inch = 1
8 Ridge width: Q20
The TNC and the machine tool must be specially prepared by
the machine tool builder for the use of the 29 CYLINDER
SURFACE
Cycle.
„
The workpiece must be set up concentrically on the rotary
table.
„ The tool axis must be perpendicular to the axis of the rotary
table.
„ Cycle 14 CONTOUR GEOMETRY can have only one label
number.
„ A subprogram can hold approx. 2048 line segments. C
Z