HEIDENHAIN TNC 360 ISO Programming - Manual (Page 42)

TNC 360 2-5
2 Manual Operation and Setup
Fig. 2.4: Knobs for spindle speed and feed
rate overrides
1 e.g. 0 0 0
I
S
END
2.2 Spindle Speed S, Feed Rate F and Miscellaneous Function M
The following values can be entered and changed in the MANUAL OPER-
ATION and ELECTRONIC HANDWHEEL modes of operation:
• Miscellaneous function M
• Spindle speed S
• Feed rate F (can be changed but not entered)
For part programs these functions are entered or edited directly in the
PROGRAMMING AND EDITING operating mode.
To enter the spindle speed S
Select the S function key.
N10 S
Enter the spindle speed S, for example 1000 rpm.
Confirm the spindle speed S with the machine START button.
A miscellaneous function M starts spindle rotation at the entered
speed S.