Selecting, erasing and protecting programs -20, Selecting, erasing and protecting programs – HEIDENHAIN TNC 360 ISO Programming User Manual
Page 37

TNC 360
1-20
1
Introduction
or
or
or
e.g.
PGM
NR
5
ENT
PGM
NR
1
CL
PGM
5
ENT
NO
ENT
ENT
ENT
1.5
Programs
END
0
G
5
Selecting, erasing and protecting programs
To select a program:
Call the program management.
PROGRAM NUMBER ?
Use the arrow keys to highlight the program.
Enter the desired program number, for example 15.
Confirm your selection.
To erase a program:
Press CL PGM to call the program management.
ERASE = ENT / END = NO ENT
Use the arrow keys to highlight the program.
Erase the program or abort.
To protect a program:
Call the program management.
PROGRAM NUMBER = ?
Enter the number of the program to be protected, for example
program number 5.
Use the arrow key to highlight the first block.
Enter the function for program protection, conclude the block.
Resulting NC block: %5 G71 G50 *
Removing edit protection
To remove edit protection re-select the program and enter the code
number 86357 with the corresponding MOD function (see page 10-3).