Grass Valley Trinix v.2.4.1 - Manual (Page 207)

TRX-VI-33100 Module
Planning and Installation Manual 207
Figure 123. Picture enhancer menu for NTSC, showing setup for all 16 inputs. PAL display is
similar. (Only Input 0 is connected in this example.).
Picture Enhancer -
--------------------------------------------------------------------------------
Reference - Input 0: Line Rate: 525 Line Type: NTSC (M, J)
================================================================================
Detail Enhancer Level:
Disabled 0
Low 1
Medium 2
High 3
--------------------------------------------------------------------------------
+---------------------------- Channel Line Rate ----------+
| |
| +-------------------- Detail Enhancer |
+-------+--------------------------------------------------------------------+--
0, 0 525
1, 0 N/A
2, 0 N/A
3, 0 N/A
4, 0 N/A
5, 0 N/A
6, 0 N/A
7, 0 N/A
8, 0 N/A
9, 0 N/A
a, 0 N/A
b, 0 N/A
c, 0 N/A
d, 0 N/A
e, 0 N/A
f, 0 N/A
Press: '0 ~ 9' or 'A ~ F' to select channel to edit.
Press: 'M' to move/copy channel configuration.
Press: 'Z' to set ALL channels to factory defaults.
Press 'ESC' to return to Main Menu.
When an input (channel) is selected, the display will show the values
for that particular channel (NTSC shown):
Figure 124. Picture enhancer menu for one channel.
Picture Enhancer -
--------------------------------------------------------------------------------
Reference - Input 0: Line Rate: 525 Line Type: NTSC (M, J)
================================================================================
Detail Enhancer Level:
Disabled 0
Low 1
Medium 2
High 3
--------------------------------------------------------------------------------
+---------------------------- Channel Line Rate ----------+
| |
| +-------------------- Detail Enhancer |
+-------+--------------------------------------------------------------------+--
0, 0 525
To Set Picture Enhancer Mode press: 'Q'.
Press: 'ESC' to ABORT changes and return to the previous Menu.
Press: 'Enter' to ACCEPT changes and select a different channel.
Press: 'Y' to revert back to last settings.
Press: 'Z' to set THIS channel to factory defaults.