Grass Valley Trinix v.2.4.1 User Manual
Page 162
Broadlinx
162
Planning and Installation Manual
b.
Reboot the PC to apply the changes.
If desired, you can use the MS-DOS ipconfig command to
verify the settings.
If desired, these settings can be restored to their previous values
once the Broadlinx board has been configured.
You must have admin privileges to change Internet settings on
a Windows 2000 PC.
2.
The Broadlinx board should be booted (or rebooted) at this time.
One way to do this is to unseat and reseat the board:
a.
The board can be unseated without turning off power.
b.
To re-insert the board, keep the ejector levers spread apart and
slide the board in until the levers make contact. Then fold the
levers toward each other to seat the board.
c.
Wait for the board to boot up fully (as indicated by the
“spinning” pattern of the LEDs on the front edge of the board).
Note
The Broadlinx board should be powered up (or rebooted) after all
network connections have been made. Otherwise the board may fail to
boot properly.
3.
At the PC, start Microsoft Internet Explorer.
4.
The Explorer Proxy setting must be turned off.
To check the Proxy setting, go to Tools > Internet Options > Connec-
tions > LAN Settings.
5.
Enter the factory default URL (NR board IP address):
http://192.168.253.200
You should see the main Broadlinx web page:
Figure 92.
6.
Proceed to