Grass Valley Trinix v.2.4.1 - Manual (Page 131)

Duplication and Expansion
Planning and Installation Manual 131
Restricted Output Expansion
In this application one or more input blocks are not passed through a
splitter and are therefore not boosted. For example, in the system shown
in Figure 68 , inputs 1-16 are not split (and therefore are restricted to
outputs 1-512).
Figure 68.
In this example:
• For SI-33110 and HI-33110 input boards, the gain for inputs
17-512 would be boosted by closing the rear-panel Output
Expand DIP switches on both chassis and verifying that the
on-board jumpers for that set of inputs are in the “Expand
Enable” position. The location of the boost jumpers on these
input boards is shown on page 132 . (“Base” refers to the 16
lower-numbered inputs to the main board; “Mez” refers to
the 16 higher-numbered inputs to the mezzanine board.)
The gain for inputs 1-16 must be held at unity by setting the
on-board jumper for that set of inputs to the “Force Normal”
position; this overrides the rear-panel DIP switch setting for
those inputs.
17 - 512
1 - 16
1 - 512
513 - 1024 17 - 512
17 - 512
Outputs
expanded
to 1024
(restricted)
32
PE 33016
used as
splitters
Trinix
Frame 0
512 x 512
Trinix
Frame 2
512 x 512