Grass Valley Trinix v.2.4.1 - Manual (Page 148)

Installation
148 Planning and Installation Manual
Jupiter Control
Figure 80. Control connections to Jupiter Facility Control System (example).
The Jupiter Facility Control System can be used to control the Trinix
router using a VM-3000 System Controller ( Figure 80 ). The VM can
receive switching commands from a variety of serial sources, including
Jupiter control panels or an automation computer. The new CM-4000
System Controller is also available as a control interface.
In this application, the Trinix is operated in the “external crosspoint bus
control” mode, during which the Broadlinx board releases control of
the crosspoint bus. Switch commands arriving at the crosspoint bus
connector on the rear of the chassis will be executed.
VM-3000
System
Controller
MPK bus
Trinix routing
switcher(s)
Crosspoint bus
Jupiter control panels
T
Crosspoint bus
terminator
Media
converter
or hub
Jupiter file
server
10/100BaseT
LAN
10Base2
LAN
T
T
T
Ungrounded
50-ohm terminator
=