To repeat at the end of a playlist, To pause at the end of a section, To pause at the end of an event – Grass Valley K2 AppCenter v.7.2 User Manual
Page 97

05 April 2010
K2 AppCenter User Manual
97
Adding play effects
•
“To pause at the end of a section” on page 97
•
“To pause at the end of an event” on page 97
•
“To add pauses or transitions to all events in a playlist, section, or event” on
•
“To remove pause from all events in a section” on page 100
To repeat at the end of a playlist
You can loop on a list until you manually stop playing.
1. Open the list properties dialog box by doing one of the following:
• Select the list icon in the event list, then click the
Properties
button.
• Right-click on a list and select
Properties
.
2. Click
End
, then choose the
Repeat
option.
3. Click
OK
to close.
NOTE: If you leave a player channel in Loop mode, a remote protocol-controlled
playlist might either miss all of the events and stop or simply cue the clip and not play.
To pause at the end of a section
To pause at the end of a section:
1. Select the section.
2. Open the properties dialog box by doing one of the following:
• Select the section icon in the event list, then click the
Properties
button.
• Right-click on a section and select
Properties
.
3. Click
End
.
4. Select the
Pause
drop-down list. Use the drop-down list to choose whether to
Freeze on last frame, Freeze on next event, none, Show black
or
Show E-to-E
.
5. Click
OK
.
Based on your selection, the section repeats when it comes to the end or each
event's properties are modified to include the specified pause type. During
playback, each event will remain paused at its end until you intervene. The pause
symbol
appears in the corner of the event thumbnail.
To pause at the end of an event
1. Select the event.
2. Open the properties dialog box by doing one of the following:
• Select the list icon in the event list, then click the
Properties
button.
• Right-click on a list and select
Properties
.
3. Click
End
.