beautypg.com

Type, Name, If desired, enter a name for the channel – Grass Valley K2 AppCenter v.7.2 User Manual

Page 160: Video output, Ntsc (sd) or pal (sd), Aspect ratio conversion, Still-play mode, Test mode (colorbars + tone), Video output timing, Line offset (coarse)

background image

160

K2 AppCenter User Manual

05 April 2010

Chapter 10 Audio/Video Configuration

To access play channel video settings, open Configuration Manager, click

Channel

,

and select a channel.

For this setting...

Configure as needed…

Type

If licensed for AppCenter Elite you can configure the channel to be a
ChannelFlex Suite Channel. When you do so, settings change accordingly.
Refer to

Chapter 13,

ChannelFlex Suite

.

Name

If desired, enter a name for the channel.

Video Output

NTSC (SD) or
PAL (SD)

NTSC or PAL available depending on video reference
standard setting. Selecting a SD format makes the following
setting(s) available below:

VITC Output

720p

1080i
(1920x1080i)

Aspect ratio
conversion

Bar
Crop
Half Bar
Stretch

Refer to

“About video scaling settings” on page 152

.

Still-play mode

a

Field
(interpolated)

This is the default setting and uses the content of one field
for both fields during still-play for a one field freeze. This
mode eliminates the motion jitter that can be present in
Interlaced mode.

Frame
(interlaced)

This mode displays two fields in still play mode for a two
field freeze. With this mode you might see some motion
jitter in still-play.

Test Mode
(Colorbars + Tone)

On
Off

Temporarily displays 75% colorbar signal on the channel
output. It also generates an audio tone on all audio outputs.
This setting is for test purposes only, so it is not saved.

Video Output
Timing

Line offset
(coarse)

Delays the video output. Range: NTSC 0-524 lines; PAL
0-624 lines.

Sample offset
(fine)

Delays the video output. Range: NTSC 0-1715 clock
samples; PAL 0-1727 clock samples.

Ancillary data
timecode output

b

Ancillary LTC
(Yes/No)

If 720p or 1080i selected:
Inserts the recorded timecode track as LTC ancillary
timecode on playout. Overrides any LTC ancillary timecode
packets stored on data track. Refer to the

“Data track

support on K2 Summit/Solo HD channels” on page 218

for

specifications.

Ancillary VITC
(Yes/No)

If 720p or 1080i selected:
Inserts the recorded timecode track as VITC ancillary
timecode on playout. Overrides any VITC ancillary
timecode packets stored on data track. Refer to the

“Data

track support on K2 Summit/Solo HD channels” on
page 218

for specifications.

This manual is related to the following products: