Grass Valley K2 AppCenter v.7.2 - Manual (Page 161)

05 April 2010 K2 AppCenter User Manual
161
Play channel audio setup
Play channel audio setup
To access play channel audio settings, open Configuration Manager, click
Channel
,
and select a player/recorder channel.
Adjusting play speed options
To access play speed settings, open Configuration Manager and click
Panel
.
VITC output
generator On If SD selected:
Makes the following setting(s) available below:
VITC line 1
VITC line 2
Off —
VITC line 1 Selectable between 10 and 20 (NTSC) or between 6 and 22 (PAL).
VITC line 2 Selectable between 10 and 20 (NTSC) or between 6 and 22 (PAL).
a. Still-Play mode settings determine how to generate the still-play signal for the play channel when it is
setup to freeze on last frame of video in stop mode. You can select interpolated or interlaced.
b. Refer to “Changing the timecode source” on page 18
For this setting... Configure as needed…
Embedded output
group(s) None
Groups 1, 2, 3, 4
Timing offset Between -200 ms and +200 ms. The default is 0 ms.
Audio Output
Tags Add tags for languages or other purposes to this channel’s audio
tracks. Refer to
“Adding audio tags” on page 180 .
Display audio
meters Select
System | Monitor Options
, select the
Display the Following
Channel Status
radio button, and and check the
Audio Monitors
box.
For this setting… Configure as needed…
Jog speed -1X to 1X
-1X to 3X Playback advances or retards one frame at a time according to
the direction of the setting.
Shuttle speed -16X to 16X
-32X to 32X Sets the speed for shuttle play or playback.
VAR setting 0.25X
0.50X
0.75X Variable speed play. Specify the play speed; otherwise, the
speed remains at the preset play speed or the last variable play
speed used.
Always start at
VAR preset Yes
No Initial play speed can be set to start at the preset speed.
For this setting... Configure as needed…