Grass Valley K2 AppCenter v.7.2 User Manual
Page 49

05 April 2010
K2 AppCenter User Manual
49
Guide to using the Recorder/Player application: Cue view
Control
Description and User Operation
1
Assignable Buttons
Assignable buttons allow you to modify the button assignments to
best suit your workflow. Hold down the left mouse button to open a
pop-up menu that lists the alternative button choices.
Add Cue
– Used to add a cue to a recording:
1. In the Control view, start the recording.
2. Select the
Cue
tab.
3. At the desired timecode, select
Control | Add Cue
.
Remove
– Used to remove a cue.
Go To
– Jumps to a selection, the next cue, or a specified timecode.
Rename
– Used to rename a cue.
Create Clip
– Creates a sub clip from highlighted cue points.
Create All
– Creates sub clips from all cue points.
Cue selection
- Jumps to the selection point and pauses.
2
Current Timecode
Indicates the current timecode of the timecode source selected for the
channel. Text color is white during record, and dimmed at other
times. The timecode value of XX:XX:XX:XX is displayed when the
timecode source is not present or is invalid.
3
Timecode Source
Indicates the mark in, mark out, and cue points of the recording
session.
4
View tabs
These tabs toggle between Control view and Cue Points view.
Recorder Cue View
Control Menu
In addition to commands described in the Assignable Buttons section,
the Control menu of the Cue view contains the following option:
E-to-E mode – When selected, the following occurs: “EE” is
displayed on the channel pane, next to the Timecode Source
indicator; when no clip is loaded, the signal that is currently present
at the channel input plays out; when a record operation stops the clip
remains in the Recorder. The signal that is currently present at the
channel input plays out.
Control
Cue