Grass Valley K2 AppCenter v.7.2 - Manual (Page 63)

05 April 2010 K2 AppCenter User Manual
63
Selecting the Player application in AppCenter
Selecting the Player application in AppCenter
The Player application requires a single play channel. If the play channel is currently
being used in another application, such as a Playlist application, you can use the
following steps to select the Player application. Selecting the Player application
causes the play channel operation to stop, then the Player application is started.
To start the Player application on a play channel:
1. In the monitor pane, select the control mode drop-down list for the play channel,
then choose
Player
.
The channel switches to the Player application and becomes the selected channel.
Guide to using Player: Control view
The Control view allows you to play a clip, modify its name, adjust mark in and mark
out points, create sub-clips, and stripe timecode. Selecting the
Control
view tab shows
the Control view. The following describes the essential controls in the Control view.
Control Description and User Operation
1 Assignable Buttons Assignable buttons allow you to modify the button assignments to
best suit your workflow. Hold down a button to open a pop-up menu
that lists the alternative button choices.
The Subclip button toggles between the Source Clip and Subclip
settings.
Clip
Timecode
Thumbnail
(Click to change
thumbnail)
View
Tabs 2 3 Clip Name &
Current Bin
(Click clip name
to rename.) Assignable
Buttons
(Default buttons
are shown) 1
7 Time Dome
(Click to select
loop-play mode)
5
Meter Bar
Button
(Click to adjust
audio level) Mark-In &
Mark-Out
(Click to set to
current frame
timecode) 8 9
Countdown
Timecode 4
Application 6 10 Channel
Flex 11